Craftsman 320.17255 Manual De Operaciones página 24

TO MAKE SHARP CORNERS
1. Cut up to the corner, then back up slightly before rounding the corner.
2. After the opening is complete, go back to each corner and cut from the opposite
direction to square it off.
TO ADJUST BASE PLATE FOR BEVEL CUTTING (Fig. 21)
WARNING"
ALWAYS unplug saw from the power source BEFORE
making any adjustments orattaching accessories.
CAUTION"
To prevent damage to the tool when angle or bevel cutting,
the scroll mechanism MUST BE locked in place with the cutting edge of the
blade facing the front of the tool.
NOTE: ALWAYS remove the blade
before adjusting the cutting angle.
1. To adjust the cutting angle, first turn
the tool upside down and remove the
bevel assist handle from underneath
the saw.
2. Use the hex key built into the end
of the bevel assist handle to
loosen the hex screw under the
base of the saw (see Fig. 21).
3. Move the base of the saw slightly
forward and tilt it to the desired
angle between 0 ° and 45 °,
using the scale marked
on the base bracket. (see Fig. 21a)
4. Install a cutting blade.
5. Slide the blade guide assembly
until the blade guide rests against
the back edge
of the blade.
6. Re-tighten the
hex screw. For
accurate work,
it is necessary
to make a trial
cut, measure
the work, and
reset the angle
until the correct
setting is
achieved.
Fig. 21
©
24
Fig. 21 b