Installing The Heater Sensor With Excess Temperature Fuse - Karibu 70444 Instrucciones De Montaje Y De Servicio

Instructions for installation and use

4.3. Installing the heater sensor with excess temperature fuse

Refer to Fig. 4 (page 12).
ATTENTION!
Sources of interference can have a negative effect on signal transmission
● Lay the heater sensor wires separately from other mains wires and control
wires.
● Protect wires with only one layer of insulation by using a pipe (double insulation).
1. Lay the two 2-pin heater sensor wires 3 in the wall of the sauna cabin, lead
them to the location where the heater sensor is installed, and secure the
heater sensor wires using wire clips.
2. Install the heater sensor on the rear of the cabin using the two included wood
screws 2 (16 mm). The optimum position is above the middle of the sauna
heater. Maintain a distance of 15 cm to the sauna cabin roof.
Fig. 4
WORLD OF WELLNESS
1
2
3
1
2
3
p. 12/22
Heater sensor
Wood screws (16 mm)
Heater sensor wires