About Memory; Using The Monitor With Ac Adapter - A&D Medical LifeSource UA-767 Plus Guía De Instrucción

ABOUT MEMORY

This monitor automatically stores up to ninety (90) blood pressure and pulse
measurements in memory. Measurements stored in memory are assigned in
the order of the newest to the oldest. The M symbol in the upper left corner
of the display screen indicates that you are reviewing a previous measurement
stored in memory.
To retrieve readings, follow these simple steps:
1.
When the display screen is blank, press and quickly release
the Memory ("M") button. You will see the average blood
pressure reading displayed. Press and quickly release the
Memory button again. You will see the most recent reading
followed by the measurement.
2.
If you want to retrieve other measurements in memory,
press and release the Memory button repeatedly in the
order of the newest to the oldest. The measurement will
then be displayed.
3.
The display will shut off automatically a few seconds after
the readings are displayed.
To clear the measurement history from memory, press and hold the Memory
button for at least five seconds while the display screen is blank. Release the
button when you see the M symbol flash and disappear in the upper left
hand corner of the display. This indicates that the memory has been cleared.
If there are no measurements stored in memory, the display will show only
dashes.
NOTE: Stored measurements will be lost if batteries become low or are
removed.
E-10 LifeSource Health Line (Toll-Free): 1-888-726-9966

USING THE MONITOR WITH AC ADAPTER

The UA-767 Plus has an AC adapter jack to allow you to supply power from
an outlet in your home. We recommend you use only the exclusive AC
adapter to avoid potential damage to the monitor. Please contact A&D
Medical at 1-888-726-9966 (in Canada - 1-800-461-0991) if you would like
to purchase the AC adapter.
Connecting the AC adapter to the monitor:
1.
Gently insert the AC adapter plug into a 120V AC outlet.
2.
Connect the AC adapter plug into the jack on the right side
of the monitor.
Disconnecting the AC adapter from the monitor:
1.
Turn the unit off by pressing the START button.
2.
Disconnect the plug from the jack of the monitor quickly.
3.
Gently remove the AC adapter from the outlet.
NOTE: If monitor has batteries installed and an AC adapter connected, the
measurements stored in memory will be lost if AC adapter is unplugged
from the wall first. To ensure that measurements remain in memory, make
sure the unit is off and that the jack plugged into the monitor is removed
quickly before unplugging adapter from the wall.
Plug
In Canada–Auto Control Medical (Toll-Free): 1-800-461-0991
Jack
AC Adapter
E-11