Connecting Charger To Power Supply; Charging The Battery - Stihl MSA 200 C Manual De Instrucciones

Connecting Charger to
Power Supply
Mains voltage and operating voltage
must be the same.
Insert the mains plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
MSA 200 C

Charging the Battery

When delivered, the battery is not fully
charged.
It is advisable to charge the battery
completely before using it for the first
2
time.
1
Connect the charger to the power
N
supply – mains voltage and
operating voltage of the charger
must match – see "Connecting the
charger to the power supply"
Operate the charger only in a closed, dry
space at ambient temperatures of +5 °C
to +40 °C.
Slide the battery (1) into the
N
charger (2) until you start to feel
resistance – then push it in until it
engages
After insertion of the battery, the LED (3)
on the charger is on – see "Light-emitting
diodes (LED) on charger".
The charging process begins as soon as
the LEDs (4) on the battery are green –
see "Light-emitting diodes (LED) on
battery".
The charging time is dependent on
different factors such as battery
condition, ambient temperature, etc. and
can therefore deviate from the specified
charging times – see "Specifications".
2
The battery warms up in the machine
during use. If a warm battery is inserted
in the charger, it may be necessary for
the battery to cool off before charging.
The charging process does not start until
the battery has cooled off. The charging
time can be extended by the cooling off
period.
The battery and the charger warm up
during the charging process.
AL 300 charger
The charger is equipped with a fan for
cooling the battery. The fan can be
heard during operation.
English
3 4
71