Connecting The B1 Bass Module - Bose L1 Model II Guía De Usuario

Svenska Nederlands
S S
YSTEM ETUP

Connecting the B1 bass module

Figure 5
B1 bass module
12
Italiano Français Svenska
You can place the B1 or B2 bass module either vertically or horizontally on the floor. It fits
neatly between the legs of the power stand.
1. Plug one end of the B1 or B2 bass module cable into one of the bass connectors. Rotate
the plug clockwise to lock it in place. You should hear a soft click as it locks.
2. Plug the other end of the cable into the Bass Module Out connector on the power
stand. Rotate the plug clockwise to lock it.
Note: To disconnect a B1 or B2 cable, slide back the metal tab on the body of the plug, rotate
the plug counterclockwise, and pull it out of the connector.
B1
CAUTIONS:
• DO NOT connect a B1 bass module to two power stands at the same time.
• DO NOT connect any bass module other than the B1 or B2 to the power stand.
• DO NOT substitute the supplied cable with a 2-wire speaker cable. Use only the supplied
4-wire cable to connect the bass module to the power stand. The power stand uses the
signals on two of the wires (or the position of the B2 rear panel switch) to automatically
sense how many bass modules are connected.
Nederlands Español Français Deutsch Italiano
B2
Bass Module
Out
Deutsch Español Dansk English English Dansk
Bass Module
Out