Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
* The time setting for power of 50 Hz (the water
temperature is between 10 y 20 ºC) is listed as
below:
Alginate cups
1
2
3
* The time setting for power of 60 Hz (the water
temperature is between 10 y 20 ºC) is listed as
below:
Alginate cups
1
2
3
!
IMPORTANT
1. The mixing time shall adopt in average. If
there is any difference between water
temperature established by the supplier of
alginate impression material, the setting
time will be different.
2. Please set on the proper mixing time.
MANTENANCE
1. Before cleaning or maintenance, disconnect
the unit.
2. Do not clean the unit while running or hot.
3. Mixing bowl:
After
setting,
the
material inside the bowl can be cleaned and
removed easily. The small hole at the center
of cap shall be cleaned very often (Fig. 13).
! IMPORTANT
1. The small hole at the center of cap shall
be cleaned very often. If jam, the cover
will be very hard to open or close.
2. The water remained in the bowl after
cleaning shall be removed completely.
Otherwise it will cause error calculation to
next use.
14
Mixing time
(seconds)
7 - 10
8 - 11
9 - 12
Mixing time
(seconds)
6 - 9
7 - 10
8 - 11
remains
impression
Fig. 13
4. Cleaning:
If there is any dirt on the mixer, please use cloth
to wipe. If it is serious, then please use a neutral
cleaning agent.
Clean the unit at least once a week.
ATTENTION:
Never use solvent or volatile oil to swipe for
cleaning, that will cause surface faded.
Tabla de contenido
