Mestra 100191 Manual Del Usuario página 13

Mezcladora automática de alginato
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Note: Perform the above operations quickly to
prevent the alginate mixture hardening too soon.
Keep in mind that the longer the preparation
lasts, the less time will be left to work before the
mixture hardens.
Close the cover of mixer properly. Make
10.
sure whether the cover has been closed
properly. If not, the mixer cannot be
started on.
Meet the mixing amount to set the
11.
required time by timer (
"Setting
for
Mixing
complete the setting, then press down
the start button (Fig. 11). The digital
display will count second by second till
the time of completion. The cover of
mixer is fully locked when running, so it
is very safe as unable to open.
! NOTE
To protect the motor, the power will be
gradually adjusted when starting to reach
maximum speed in approximately 2 seconds.
! IMPORTANT
The hardening time of the alginate depends
on the mixing time that is programmed in the
mixer. To have enough time to work, set the
mixing time as short as possible.
Fig. 9
Fig. 10
refer to the
please
Time").
When
Fig. 11
Note:
▪ Work and hardening times increase the lower
the
water
temperature.
temperature increases, these times are
shortened.
▪ The hardness of the water causes the same
effect: the higher the hardness of the water
used for the mixture, the shorter the working
and hardening time.
! IMPORTANT
If intends to stop running, press down the
STOP button and the mixer will be stopped
immediately. If finds any abnormal condition
during running, the mixer shall be stopped
immediately. Send it to repair.
12. After making sure that the mixer has been
stopped, the cover can be opened to take
the mixing bowl out. Use the spatula to have
the mixture out (Fig. 12).
SETTING THE MIXINT TIME
1. The timer has 3 programs established by the
manufacturer that you can change.
Memory
1
2
3
2. Press
down
the
SELECT to select the time required for
mixing.
3. To alter the memory of mixing time
established by the manufacturer, you can do
adjustment by pressing the button UP or
DOWN to key in the required mixing time.
The maximum time is 16 seconds. You can
make the adjustment second by second.
ATTENTION:
Increased mixing time accelerates hardening
of impression material.
English
As
the
water
Fig. 12
Mixing time
(seconds)
8
10
12
button
of
MEMORY
13
Tabla de contenido
loading

Tabla de contenido