Promax GV-698+ Manual De Instrucciones página 64

The modifiable field has a cursor underneath that can be moved turning
encoder and be selected pressing the encoder. When it is selected the first digit of the
field flashes and if then encoder is turned it hops through the different options of this
field. Once we have selected the desired value we push the encoder; then we can start
a new selection.
If it is desired to store the new configuration, we will turn the encoder until
selecting MEMORY field. Next we will push the encoder until hearing a beep, in the
display will appear the memory number and a question 00?, we will turn encoder until
obtaining the number of memory that we wish (0 to 31) and will push the encoder to
store it. With this operation we will have stored in the selected memory all the
parameters of the generator, as much those of the display as the position in which are
all the keys of the generator.
MEMORY
Shows the active memory position. At start up the initial position is 00. In order
to activate another memory this field has to be selected with the encoder and
then press it (the first digit will flash). In this situation we can change of memory,
turning the encoder and pushing it to confirm it is the memory that we wished. If
we maintain the pressure until a beep is heard we will be able to store the
configuration that we have in another value of memory.
COLOR
Selection of the colour system among PAL, SECAM and NTSC.
SYSTEM
Selection of the television system among B / G, I, D / K, L, M and N.
SOUND
Selection of the sound system among MON (monophonic), NIC (NICAM), ZWE
(Zweiton), EXm (outer mono), EXz (outer Zweiton) and OFF (without sound
carrier), according to selected standard.
ATTENUATOR
Il selects the attenuation of the RF signal in 10 db steps between 0 and 50 db.
CHANNEL
Selection of the tuning mode between tuning by frequency FREQ and tuning by
channel, in this later case the display will show the name of the Channel Set
CCIR, STDL, OIRT or FCC (based on the stored Stes, see appendix A).
CH-FREQ
Selection of the RF frequency output. In the mode of tuning by east frequency
parameter can vary between 37 MHz and 865 MHz in 50 progressive jumps of
KHz. In the mode tuning by channel it appears the name of the channel.
Page 20
Colour pattern generator GV-698+
07/2018