Choosing A Campsite; Set Up; Bag Awning; Privacy Room (Optional) - Dometic REVO ZIP 200 Manual De Instalacion Y Uso

200, 240, 270, 310, 350, 400, 450

5.2 Choosing a campsite

Choose a flat site that is protected from the wind. Sloping ground can affect your finished bag awning.

5.3 Set up

CAUTION!
Risk of injuries due to sharp pegs!
Injuries are possible.
• Do not let children play near the bag awning and wear gloves when pegging.
CAUTION!
Risk of tripping due to storm protection straps!
Injuries are possible.
• Do not let children play near the bag awning.

5.3.1 Bag awning

To protect the bag awning lay out a groundsheet or bag awning floor covering before unpacking.
1. Unpack the bag awning and check the content for completeness.
2. Lay down the bag awning and align it with the keder strip towards the motorhome/caravan.
3. Roll out the bag awning completely (fig. 1 , on page 2).
4. Insert the bag awning into the bag awning rail (fig. 2 , on page 2).
NOTE:
For easier installation on the motorhome/caravan, let someone hold the weight of the bag awning.
5. Pull the support poles out from the hub and bring them to the ground (fig. 3 , on page 2).
6. Unlock the clamps and adjust the support pole to the correct height before locking (fig. 3 , on page 2).
7. Unfold the roof-side support strut and click it into the holder of the transport bag (fig. 4 1, on page 2).
8. Make sure that the roof-side support strut is properly tensioned and locked into one of the press release holes (fig. 4 2, on
page 2).
9. Fix the support poles to the ground with a peg (fig. 6 , on page 2).
10. Attach the storm protection in the keyhole (fig. 5 , on page 2).
11. Fix the storm protection to the ground with a peg (fig. 6 , on page 2).
NOTE:
Fix the pegs into the ground at an angle of 45° in relation to the ground.
NOTE:
Do not overtighten the straps.
12. Repeat the procedure on the other side.

5.3.2 Privacy room (optional)

To protect the panels lay out a groundsheet or bag awning floor covering before unpacking.
1. Unpack and identify each of the panels and lay them out at their correct place (fig. 8 , on page 2).
2. Zip the side panels onto the bag awning (fig. 9 , on page 3).
3. Slide the keder strip of the front panel through the track of the bag awning hub (fig. 0 , on page 3).
4. Zip the front and side panels together (fig. a 1/2, on page 3).
5. Use the velcro straps to attach the side panels to the roof-side support struts (fig. a 3, on page 3).
6. Attach the ladder straps to all pegging points (fig. b 1/2, on page 3).
7. Fix the pegging points on doors and openings crosswise (fig. b B, on page 3).
8. Fix all remaining pegging points (fig. c A, on page 3).
NOTE:
Fix the pegs into the ground at an angle of 45° in relation to the ground.
EN
4445103142
Using the bag awning
7