Lubricating Oil - SPORTSTECH F50 Manual De Instrucciones

ADJUST RUNNING BELT TO THE MIDDLE
When you use the treadmill, the force of feet is different, and pressure on running belt is unbalanced, which makes
the running belt deviate from the centre. Such deviation is normal. It will return to the centre when nobody is running
on the running belt. You need to adjust it to the centre. if it fails to return to the centre..
1. Keep the treadmill in no-load running and adjust speed to 6KM/H.
2. Observe the distance from running belt to left and right edgestrips
• If the running belt tilts towards the left, turn the left screw by 1/4 of a circle clockwise with Allen wrench.
• If the running belt tilts towards the right, turn the right screw by 1/4 of a circle clockwise with Allen wrench.
• If the running belt is still not in the middle, repeat the above steps until it is in the middle.
3. Adjust speed to 16KM/H after adjusting running belt to the middle, and observe deviation of running belt and
smoothness of running. Repeat steps of adjustment in case of deviation.
4. Warning! Please don't tighten the roller excessively! This will cause permanent damage to the bearing!
You need to tighten the running belt again if the above steps fail to reach the effect.
Adjust running belt to back of treadmill on both sides

LUBRICATING OIL

The treadmill is oiled when leaving the factory, but lubricity of treadmill shall be inspected frequently, which helps to
keep it in optimum state. The treadmill must be oiled after 1 year or running for 100h.
Lift one side of the running belt and touch the surface of running platform after running for 30h or 30 days. It is
unnecessary to lubricate if there is silicone oil; if the surface is clearly dry, please oil it as instructed below.
Please use non-petroleum silicone oil
107