Black and Decker DR260 Manual De Instrucciones página 9

• Always unplug the drill when attaching or removing accessories. When attaching
Drilling
accessories in the drill chuck, it is important to securely tighten the chuck using all three
holes to prevent slippage. When using a keyless chuck, hand tighten firmly.
• Use sharp drill bits only.
• Support and secure work properly, as instructed in the safety instructions.
• Use appropriate and required safety equipment, as instructed in the safety instructions.
• Secure and maintain work area, as instructed in the safety instructions.
• Plug in drill. Make sure switch turns drill on and off.
• Run the drill very slowly, using light pressure, until the hole is started enough to keep the
drill bit from slipping out of it.
• Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting
but not so much as to stall the motor or deflect the bit.
• Hold the drill firmly with both hands to control its twisting action (figure A).
• Use side handle if drill (DR560) is equipped with one.
• DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF AND ON IN AN ATTEMPT
TO START IT. DAMAGE TO THE DRILL CAN RESULT.
• Minimize stalling on breakthrough by reducing pressure and slowly drilling through the
last part of the hole.
• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce jamming.
Holes in wood can be made with the same twist drill bits used for metal or with spade bits.
Drilling In Wood
These bits should be sharp and should be pulled out frequently when drilling to clear chips
from the flutes.
Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which
Drilling In Metal
should be drilled dry. The cutting lubricants that work best are sulfurized cutting oil or lard oil.
Problem
• Unit will not start.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
Troubleshooting
Possible Cause
• Cord not plugged in.
• Forward/reverse slider not fully
depressed in desired direction.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
9
Possible Solution
• Plug tool into a working
outlet.
• Push slider completely to
the left or right.
• Replace circuit fuse.
(If the product repeatedly
causes the circuit fuse to
blow, discontinue use
immediately and have it
serviced at a Black &
Decker service center or
authorized servicer.)
• Reset circuit breaker.
(If the product repeatedly
causes the circuit breaker
to trip, discontinue use
immediately and have it
serviced at a Black &
Decker service center or
authorized servicer.)
• Have cord or switch
replaced at Black &
Decker Service Center or
Authorized Servicer.