JENN-AIR JB36NXFXLE Manual De Instrucciones página 26

Install Top Grille Panel
B
A. Top grille panel
B. Cabinet sides
Standard Integrated Grille Installation
1. Hook the panel brackets onto the mounting bolts extending
from the top of the refrigerator.
A. Panel brackets
B. Grill trim piece
2. Pull the grille panel down slightly to lock into place.
Fully Integrated Grille Installation—Full Height Grille
1. Align the bracket on each side of the top grille panel with the
mounting bolts.
2. Push the grille panel forward until the bracket snaps into
place.
Door Swing Adjustment
It may be necessary to adjust the swing of the door(s). Make sure
the refrigerator door(s) can open freely. If the door(s) opens too
wide, install the door stop pin (provided with refrigerator).
1. Hold the door open to a position that is less than 90°.
2. Insert the door stop pin into the top hinge in the hole shown.
3. Using a ⁵⁄₃₂" hex key, tighten the door stop pin.
A. Door stop pin hole
26
A B
A
B
A
Complete Panel Installation
1. Use the installation block to measure the gaps between the
panels and adjacent cabinets.
Custom wood overlay panels may be made with a ³⁄₈"
(0.95 cm) or ¹⁄₈" (0.32 cm) gap between the panel and
cabinets and a ¹⁄₈" (0.32 cm) gap between the freezer and
refrigerator door(s) and the door(s) and top grille.
All stainless steel panel kits require a ³⁄₈" (0.95 cm) gap
between the panel and the cabinets and a ¹⁄₈" (0.32 cm)
gap between the freezer and refrigerator door(s), and the
door(s) and top grille.
A
B
A. Adjacent cabinet
B. Installation block
2. Adjust the panel to achieve the required spacing, or to align.
IMPORTANT: If adjustments are needed, adjust the panel, not
the door. Adjust left to right in the mounting bracket before
using the pins to adjust the panel up and down or at an angle.
Slide the panel from side to side in the keyhole slot.
Use a ⁵⁄₃₂" hex key to raise or lower the adjustment pins
which allows the door panel to swivel.
C
A. Door panel
B. Panel top bracket
3. Predrill pilot holes, using an ³⁄₃₂" drill bit, into the door panel(s)
through the open holes in both the bottom and top hinges.
4. Using the slotted hex-head screws (provided with refrigerator),
attach the top and bottom hinges to the door panels. Fully
tighten all door panel screws.
NOTE: For 36" single door models, there is an additional
bracket at the top to fasten the panel to the door. Insert the
screws through the bracket into the door panel.
A
C
A. Top hinge
B. Panel top bracket
C. Holes for screws
C
C. Panel on door
A
B
C. Adjustment pins
B
D E
D. Door adjustment pins
E. Holes for screws
(36" models only)