Idiomas disponibles
Idiomas disponibles
ENGLISH
ENG
and its implementation in national legal systems,
used power tools must be collected separately
and handed in for environmentally compatible
recycling.
14 Technical Specifications
Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
P
= Nominal power input
1
P
= Power output
2
n
= No-load speed
1
n
= speed at rated load
2
dia.
= maximum solid drill diameter
max.
s
= maximum impact rate
max.
W
= Single impact force
m
= Weight without mains cable
Vibration total value (vector sum of three
directions) determined in accordance with
EN 60745:
a
= Vibration emission value
h, HD
(hammer drilling into concrete)
K
= Uncertainty (vibration)
h,HD
The vibration emission level given in this informa-
tion sheet has been measured in accordance with
a standardised test given in EN 60745 and may be
used to compare one tool with another. It may be
used for a preliminary assessment of exposure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with different
accessories or poorly maintained, the vibration
emission may differ. This may significantly
increase the exposure level over the total working
period.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not
actually doing the job. This may significantly
reduce the exposure level over the total working
period.
Identify additional safety measures
to protect the operator from the effects of
vibration such as: service the
tool and the accessories, keep hands warm,
organise work patterns.
Typical A-effective perceived sound levels:
L
= Sound pressure level
pA
L
= Acoustic power level
WA
K
, K
= Uncertainty (noise level)
pA
WA
During operation the noise level can exceed
85 dB(A).
Wear ear protectors!
12
Measured values determined in conformity with
EN 60745.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Capítulos
