Step 5 Level Unit; Step 6 Secure Unit To Wall - Monogram FZIR360NNRH Instrucciones De Instalación

Installation Instructions - Stainless Steel Installation
STEP 4 INSTALL ANTI-TIP BRACKET
(Cont.)
Move Unit into Final Position
• Move appliance toward its final installed location. Align
the tabs on the wall bracket with the openings in the
back of the unit.
• The unit has "L" bolts in the upper left and right
corners inside of the access compartment. These
bolts will interlock with the wall bracket and secure
the unit using the washers and hair pin cotters in the
hardware kit once the unit has been leveled and is in
the final position.

STEP 5 LEVEL UNIT

All models have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the unit.
• To level the back of the unit, turn the 7/16" hex nut
located above the front wheels. Turn clockwise to
raise or counterclockwise to lower the unit.
• For front leveling, use a 1-1/4" open-end wrench.
• Adjust height of unit to match installation cutout open-
ing 84-1/2" (214.63 cm). The unit should be level and
plumb with cabinetry.
The rear leveling wheels and front leveling legs are lim-
ited to a maximum height adjustment of 1"
(2.54 cm). If the installation requires more than 84-1/2"
(214.63 cm) height, the installer should elevate the unit
on a sheet of plywood or runners. Cabinetry trim could
also be added across the top of the opening to shorten
the opening. If you attempt to raise the unit more than
1" (2.54 cm), you will damage the front leveling legs
and the rear leveling wheels.
31-1000416 Rev. 0

STEP 6 SECURE UNIT TO WALL

• The "L" rods can be found in the upper left and right
corners of the unit in the access compartment. Look
through the access compartment to make sure the
rods line up with the anti-tip bracket.
• There are 2 washers and a hair pin cotter per rod.
Remove the washers and hair pin cotter from the end
of the rod.
• Rotate and move
the "L" rod into
the slot in the anti-
tip bracket tab.
Once it is in the
slot, rotate the "L"
rod so the hook
portion is pointing
down. The holes
at the front end of
the rod should be
in a vertical position. Do this to both sides.
• Pull out on the end of the rod to make sure it is
secure in the bracket.
• Locate the hole on the rod that is closest to the unit.
A hair pin cotter will be put through this hole to secure
the rod. If this hole appears to be too far away for a
snug fit against the unit, add the washers one at a
time until the pin will fit tightly into the hole.
• Align the straight section of the pin with the hole
from the underside of the rod. Push the pin up until it
snaps into position.
Pliers may be used.
NOTE: The hair
pin cotter must be
vertical when this
step is completed to ensure the "L" rod
is engaged in the
bracket.
• Check the rod for
tightness by pulling
forward. If the rod
moves, remove the
hair pin cotter and
place another washer
on the rod. Reinsert the pin.
• Replace the grille panel.
33
"L" Rod
Wall Bracket
"L" Rod