Master Forge 3218LTN Manual De Instrucciones página 16

ASSEMBLY INSTRUCTIONS
15. For right door (U), insert bottom hinge
pin into hole in the main bottom panel (S).
Push down on top hinge pin to insert into
hole on the main beam (W). Loosen the
screws holding the magnets to center
panel (K). Adjust magnets to contact the
right door, then tighten the screws again.
(Fig. 15)
16. Align the holes in the drip tray support
(AE) with the holes in the main beam (W)
and in the left rear panel (I). Insert screws (BB)
into the holes and tighten them.
Note the orientation of the drip tray support
as shown. (Fig. 16)
Hardware Used
1/4-20 x 5/8 in.
BB
Screw
15
S
16
W
X 4
16
BB
Lowes.com/masterforge
K
W
U
AE
I