Transport And Installation; Important - eurodent ABSOLUTE Guia De Instalacion

TRANSPORT AND INSTALLATION

Remove the chair from its packing and, before moving it, take the covering guard of the connecting box off, so as to make
the seizing of the chair and transport easier. Do not lift the chair by seizing the pantograph head or the legrest.
Position the chair so as to place all couplings inside the connecting box (placed at the bottom of the chair parallelogram).
Make sure that you do not inadvertently squash or tear the electrical cables of the chair when slipping it on the floor.
Pay special care to the cable of the foot-control.
Check the level evenness of the floor with respect to the bearing surface of the base. Fasten the chair by fitting the
expansion stoppers type Fischer (supplied with the accessories) into the two housings (see figure A1).
M6 expansion bolts and proper spanner are supplied with the chair.
The hole in the floor must be at least 115-mm deep.
As regards installation, we advise connecting temporarily the chair to the main supply in order to have it lifted simply
by operating the foot-control.
BE CAREFUL! Connect the backrest to the motor and to the Trendelenburg device before making it perform any
movement.
When the chair reaches the height right for operating comfortably, cut out voltage.
A1
Bolt M6 x 140
Long spacer
Expansion nut
A
A2
A
IMPORTANT: if assembly does NOT allow connection
inside the chair base box, you can use the front base
frame as outlet window, by removing the baffle plugs with
a cutter.
27
ABSOLUTE
Installation instructions
Bolt M6 x 110
Short spacer
Expansion nut
B
B