Transport And Installation - eurodent ISOTRON Guia De Instalacion

TRANSPORT AND INSTALLATION

Remove the chair from its packing and, before moving it, take the covering guard of the connecting box off, so as to make
the seizing of the chair and transport easier. Do not lift the chair by seizing the pantograph head or the legrest.
Position the chair so as to place all couplings inside the connecting box (placed at the bottom of the chair parallelogram). Make
sure that you do not inadvertently squash or tear the electrical cables of the chair when slipping it on the floor. Pay special
care to the cable of the foot-control.
Check the level evenness of the floor with respect to the bearing surface of the base. Fasten the chair by fitting the expansion
stoppers type Fischer (supplied with the accessories) into the two housings (see figure A1).
M6 expansion bolts and proper spanner are supplied with the chair.
The hole in the floor must be at least 115-mm deep.
As regards installation, we advise connecting temporarily the chair to the main supply in order to have it lifted simply by
operating the foot-control.
BE CAREFUL! Connect the backrest to the motor and to the Trendelenburg device before making it perform any movement.
When the chair reaches the height right for operating comfortably, cut out voltage.
A1
A
A2
Installation instructions
ISOTRON - ISOPLUS - ISOPLUS LITE - ISOCONCEPT
Bolt M6 x 140
Long spacer
Expansion nut
A
B
IMPORTANT: if assembly does NOT allow connection inside
the chair base box, you can use the front base frame as outlet
window, by removing the baffle plugs with a cutter.
Bolt M6 x 110
Short spacer
Expansion nut
B
29