Kenmore trio 596.76502500 Guía De Uso Y Cuidado página 8

To protect property and refrigerator from
damage, observe the following:
, Protect vinyl or other flooring with cardboard, rugs,
or other protective material
Do not use power tools when performing leveling
procedure.
To enhance the appearance and maintain performance
the refrigerator should be level
Complete any required door reversal, panel
installation and/or a water supply connection,
before leveling.
Materials Needed:
, X," hex head driver
, Carpenter's level
1. Remove toe grille.
, Grasp firmly and pull outward
to unclip.
2. Remove bottom hinge cover(s].
Place the eraser end of a pencil or similar blunt
tool in the cover notch.
3. Using hex head driver, turn the front adjustment
screws (A} on each side to raise or lower the front
of the refrigerator.
C C
Using the hex head driver, turn each of these
adjustment screws (B} to raise or lower the rear of
the refrigerator.
Using the carpenter's level, make sure front of
refrigerator is '/4" (6 ram} or '/_bubble higher than
back of refrigerator and that the refrigerator is level
from side to side.
6. Turn stabilizing legs (C} clockwise until firmly
against floor_
7. Turn adjustment screws (A} counterclockwise to
allow the full weight of the refrigerator to rest on
the stabilizing legs.
8. Replace hinge cover(s}.
Position cover into the outer edge of the hinge.
Swing the cover toward the cabinet and snap it
into place.
9. Replace the toe grille.
Notch
Location
, Use slight pressure to pry the
cover loose.
, Continue to maintain
downward pressure to the
notched side of the cover while
swinging it ofL
, For proper reinstallation, ensure the "top" marking
on the interior of the toe grille is oriented correctly.
, Align the toe grille mounting clips with the lower
cabinet slots.
, Push the toe
grille
firmly until it snaps into place.