fortress I Serie Instrucciones De Instalación página 5

Safety
Recommended Tools:
Goggles
• Always wear appropriate personal protection equipment
(PPE). Comply with the local occupational health
and safety legislation.
• Refer to the applicable Material Safety Data Sheet (MSDS).
• Work in well-ventilated area.
• Maintain a clean work area.
• Cutting I-Series produces fine particulate matter.
• Cut boards may have sharp edges (particularly
mitered cuts)�
Storage & Handling
• Boards are bundled for convenience and can, as a result,
be heavy. Take care when lifting, placing or removing from
raised pallets. More than one person may be required for
lifting depending on the length of the boards and the
number of boards within a bundle�
• When handling lengths of boards greater than 12ft
[3658mm], ensure both ends are lifted simultaneously
and evenly. Lift the boards 3ft [915mm] from each end to
provide better control.
• Handle the boards carefully. Dropping the boards (and all
high impact loads in general) can result in damage to
the profiles.
• During transportation use corner protectors where
strapping is required.
• All components should be stored completely under cover.
• When storing boards, a pallet or flat surface should be
used to support the full length of each component.
• No component should sit in water or similar.
• Avoid over-stacking and/or irregular stacking.
Safety Dust
Gloves Mask
DECKING INSTALLATION : I-SERIES
Hard-Bristled
Broom
Vacuum
5