fortress I Serie Instrucciones De Instalación página 13

Note:
• Minimum board width after ripping is 2-1/2" [63mm].
• It's recommended to rip boards upside down on your table
saw in order to see exact placement of the saw blade
relative to the feet of the board.
Fig. 2
RIP CUT
FINAL
PRODUCT
• Wherever possible, if an I-Series board has been ripped,
face the ripped edge inwards towards the other decking
boards and allow the non-ripped edge to act as the end of
the deck�
• Never fasten through the web or "feet" of the I-Series pro-
file in order to avoid cracking the I-Series board.
As shown in Fig� 3�
Fig. 3
INCORRECT
Cutting
• I-Series boards should not be cut thinner than
2-1/2" [63mm].
• If necessary rip both the first and last I-Series boards to fit
your installation space.
• Use a minimum of two fasteners per joist, evenly spaced
and a minimum of 1-1/4" [32mm] from any board edge�
SECTION VIEW
SECTION VIEW
CORRECT
DECKING INSTALLATION : I-SERIES
13