Blodgett SG2136 Manual De Instrucciones página 14

Installation
Oven Assembly
CONVEYOR BELT SUPPORT
NOTE: Conveyor belt support is shipped installed
on some units.
1. Slide the drive side conveyor support rack into
the conveyor support guides.
NOTE: The pulley on the conveyor rack must
be inside the electrical box after being
pushed into the oven. See View A.
2. Install the drive belt around the drive motor
pulley and the pulley on the conveyor rack.
View A
Locating
Pin
Pulley
See View A
Drive Side
Conveyor Rack
Pull the conveyor rack forward to tighten the
belt.
3. Secure the conveyor using the spring loaded
conveyor locating pin. See View A.
4. Slide the idle side conveyor rack into the con-
veyor support guides until it touches the drive
side conveyor rack.
NOTE: If the mounting hole cannot be lined up or
the belt is too loose, the drive motor will
need to be repositioned.
Front and Rear
Conveyor Support
Guides
Figure 7
12
Idle Side
Conveyor Rack