Fcc Information - RCA RTD396 Manual Del Usuario

FCC Information

This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
I n c r e a s e t h e s e p a r a t i o n b e t w e e n t h e
equipment and receiver.
•
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio /
TV technician for help.
WARNING: Changes or modifi cations to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
2
Ventilation
You must adequately ventilate the product. Make
sure there is adequate space around the unit
to provide proper air flow for ventilation. See
diagram.
7 cm
10 cm
7 cm
10 cm
For your safety
The AC power plug is polarized
(one blade is wider than the
other) and only fits into AC
power outlets one way. If the
plug won't go into the outlet
completely, turn the plug over and try to insert it
the other way.
If it still won't fi t, contact a qualifi ed electrician to
change the outlet, or use a diff erent one. Do not
attempt to bypass this safety feature.
Removing the power plug is the only way to
completely remove power from your product.
Make sure the power plug remains easily
accessible.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT OF WALL
OUTLET, THEN FULLY INSERT.
Note
This DVD player is designed and manufactured to
respond to the Region Management Information.
If the Region number of a DVD disc does not
correspond to the Region number of this DVD
player, this player cannot play the disc. The
Region number for this DVD player is Region 1.
10 cm