Non-Routine Maintenance; Preliminary Safety Procedures; Replacing Front Glass Panel - ifi CLOUD Serie Manual Para El Uso Y Mantenimiento

5 NON-ROUTINE MAINTENANCE

5.1 PRELIMINARY SAFETY PROCEDURES

CAUTION!
Before performing any maintenance work, the appliance must be disconnected from the
HOHFWULFLW\ VXSSO\ ³´  2))  XVLQJ WKH PDLQ SRZHU VZLWFK IRU WKH URRP )LJ  RU WKH
display unit disconnection switch (Fig. 12 pos. 1).
CAUTION!
$OO QRQURXWLQH RU FRUUHFWLYH PDLQWHQDQFH SURFHGXUHV PXVW EH SHUIRUPHG E\ TXDOL¿HG
personnel.
CAUTION!
Use protective gloves and overalls when performing any maintenance procedure.
CAUTION!
If the power cord is damaged, it must be replaced with a new cord or special device that can
be purchased from the manufacturer or technical assistance service.

5.2 REPLACING FRONT GLASS PANEL

CAUTION!
This operation must be performed by at
least three operators
- Open the rear glass slides or remove the sliding.
- Remove the screen side of the ceiling
- Loosen the clamps and remove the wires of the
front glass
- Close the rear window and open the front glass
- Insert cardboard or other protective material on the
glass sides and below the hinge of the front glass.
Such material must limit the possibility of damage
to the display in case of shock during the operation.
- Loosen the grains of pistons in the right and left
(Fig. 19 pos.A)
CAUTION!
$W WKLV SRLQW WZR RSHUDWRUV PXVW ¿UPO\ KROG WKH JODVV
- Remove the pins corresponding to the previously loose grains
 5HPRYH WKH  VFUHZV WKDW VHFXUH WKH FODPS WR WKH KLQJHV ¿J  SRV%
- Remove the glass with his clamp and place them on a work plan
- Loosen the clamp grains
 5HPRYH WKH JLE DOXPLQXP ÀDW WKDW WUDQVIHUV IRUFH RI WKH JUDLQV WR WKH JODVV
- Pull out the glass with his seal
To replace the glass repeat in reverse.
Fig.19
44
A
B