Before Starting The Engine - Sears CRAFTSMAN 580.751500 Manual Del Propietário

Maquina lavadora de alta presion
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

OPERATION
DETERGENT APPUCATION
WITH ADJUSTABLE
NOZ21JE
IMPORTANT:
USE SOAPS DESIGNED SPECIFICALLY
FOR PRESSURE
WASHERS.
HOUSEHOLD
DETER-
GENTS COULD DAMAGE THE PUMP°
IMPORTANT:
YOU MUST ATTACH ALL HOSES BE-
FORE YOU START THE ENGINE,
STARTING THE EN-
GINE WITHOUT ALL THE HOSES CONNECTED
WILL
DAMAGE THE PUMP.
Pressure washers are useful cteaning tools designed to
clean almost any surface in two easy steps+
=
The flint step involves applying an appropriate deter-
t/€_etVent solution to penetrate and loosen grime.
tergent is applied at low pressure to avoid
splashing, overspraying and was tp.. Leaveme .soButton
on surface for 3 to 5 minutes to allow somtion to WORK.
o
The second step involves cleaning the surface you
have prepared with the pressure washer and then
rinsing it clean+
To apply detergent follow these steps:
o
Hook up water supply (Fig° 16).
o
Adjust nozzle to select high pressure mode_
NOTE:
Detergent will not flow when in the high pressure
mode_
o
Start washer and work from the top of the surface to
the bottom+
NOTE: The high pressure mode is most effective when the
tip of the wand is held between 8 inches to two feet from
the surface being cleaned.
QUICK+CONNECT
WATER SUPPLY
,,
Prepare your detergent
soluUon as required by
your job.
,,
Place small filter of the
clear, detergent siphon-
ing tube into the deter-
gent container (Fig. 14)+
o
Set nozzle to tow pres-
sure mode. Detergent is
not siphoned in the high
pressure mode (Fig° t2)..
FIG. 14
l
INCREASE_
o
Start washer and apply
detergent to a dry' sur-
face, starting
from the
bottom and working up.
You can adjust the con-
centration
of detergent
by tuming the knob on
the detergent
injector
(Fig_ 15).
Turn knob clockwise or
remove siphon from bot-
tle to stop flow of deter-
FIG. 15
gent
in tow pressure
mode.
NOTE: Detergents are most effective when applied to a dr,/
surface+
PRESSURE
WASHING/RINSING
WARNING:
BE EXTREMELY
CAREFUL
IF YOU
MUST USE PRESSURE
WAStiER FROM LADDER,
SCAFFOLDING
OR ANY OTHER RELATIVELY UN-
STABLE
LOCATION.
PRESSURE
IN A RUNNING
WASHER
BUILDS IN THE WAND AS YOU CLIMB.
WHEN YOU PRESS THE TRIGGER, THE RECOIL
FROM THE INITIAL SPRAY COULD FORCE YOU
TO FALL, OR IF YOU ARE TOO CLOSE TO THE
CLEANING SURFACE,
HIGH PRESSURE
COULD
FORCE YOU OFF CLIMBING APPARATUS.
FIGo 16
HOW TO USE OPTIONAL TURBO NOZZLE
o
The rotating turbo nozzle, in essence, expands the
area of the high pressure stream.
e
You cannot adjust the spray pattem with this nozzle,
o
You cannot apply detergent with this nozzle,,
STORING NOZZLES
A holder for the nozzles is included on the base,+ You can
keep the adjustable nozzle in this holder (Fig. 17) or even
the optional turbo nozzle.
OPTIONAL TURBO NOZZLE
FIG. 17
BEFORE
STARTING
THE ENGINE
To operate the engine you will need the following:
ENGINE OIL
IMPORTANT:
ANY ATTEMPT TO CRANK
OR START
THE ENGINE BEFORE iT HAS BEEN PROPERLY SERV-
ICED WITH THE RECOMMENDED
OIL RESULTS IN AN
ENGINE FAILURE,
A 27 oz., bottle of SAE 30 weight oil is included in the parts
carton,,
Tabla de contenido
loading

Tabla de contenido