KEY HT GC500
1 - Buttons
2 - Indicators
11 buttons (1a, 1b, 1c) operate as controls.
The front panel also hosts some luminous indicators (2, 2a, 2b, 2c).
3.1 Buttons (ref. to fig. 1)
Button
OFF/RESET
PROGRAM
MODE UP
MAN
MODE DOWN
Ref. 1b
AUTO
TEST
Fig. 1 – Front Panel HT GC500
Function
The generator is disabled; warnings and lockouts are cancelled.
You can access to parameters programming.
Gen-set is in manual mode.
Press the START
button to start the engine.
Press the STOP
button to stop the engine.
HT GC310/HT GC350 - The KM/KG
mains uses to group uses and vice-versa.
HT GC500 - The GCB
change/switches according to the plant's SW and HW configuration.
With the BUS under power-on condition, synchronization is required.
Gen-set is in auto mode: all functions are controlled automatically. Press the
START
button to enable/disable the TEST mode; pressing the STOP
button allows complete power-off (while activating a lockout).
HT GC310/HT GC350 - The KM/KG
mode
TEST
).
HT GC500 - The GCB
and depending on the plant's type and configuration).
The activation of a suitably configured external input (or receiving a given command
via SMS or from a serial port) can force the starting of the generator and the load
outlet with the mains present or with the inhibition input on (REMOTE START).
button is used to manually switch from
button is used to manually control the
button allows switching uses (only in
button allows switching uses (only in TEST
User's Manual HT GC310/HT GC350/HT GC500
mode
5