Engine Measurements (E.xx); Pmcb (B.xx) Ht Gc500; History Logs (H.xx) - HUEGLI TECH HT GC310 Manual De Instrucciones

3.4.4

Engine measurements (E.xx)

This mode shows the measurements of the engine operation parameters.
Page E.01 displays the main engine measurements (oil pressure - bar -, coolant temperature - °C - and r.p.m.).
Page E.02 displays the start-up battery voltage (V) and the fuel level (%).
Page E.03 displays the start-up and operating hours counter (partial and total operation hours, hours under load,
Override hours, remaining hours to the next service).
Numer of displayed pages can vary depending on the engine type (J1939, MTU o without communication interface).
Pages E.04, E.05, E.06, E.06 (only available with CANBUS configuration enabled) display measures acquired through
CANBUS.
Note: Depending on engine models some parameters may not be displayed.
3.4.5

PMCB (B.xx) HT GC500

Page B.01 displays voltage and frequency measurements related to the generator and to the mains/bus.
Page B.02 displays syncronization information. Using the displayed syncronoscope in MAN mode, allows you to
perform manual syncronization (refer to par. 3.5.1).
Page B.03 displays the parameters used to monitor parallel operation. This windows allows you to change the power
supplied in the mains parallel applications in BASE LOAD and IMPORT/EXPORT operation.
Page B.04 displays information about mains control cards (e.g. MC100).
Pages B.05, B.06, B.07 display PMC-Bus line related information (active and reactive power, total active and reactive
energy meters) and active and reactive power measurements for each individual generator.
Pages B.08, B.09 display information about load function. These ones include the number of devices connected to the
mains, the operating mode of the load function, the identifier of the pilot generator and the priority list.
For load function configuration refer to EAAM0322XX (Parameters table).
3.4.6

History logs (H.xx)

This mode allows you to access events and data log display.
A number and time&date stamp identifies each record.
The number shows in the top right line of the multifunctional display with the total number of records.
When the archive is full, a new record overwrites the old one so that the identification number may change in time.
Press the ACK/ENTER
function.
button to enable mode. A menu will guide you through the selection of the required
User's Manual HT GC310/HT GC350/HT GC500
15