Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. More advanced operation
3. When track memory number is shown in the
LCD, pressing the ENT key recalls the track
from the track memory number.
NOTE
... Cue and loop points can be memorized
and/or recalled. However, just after the
recall operation, seamless start from the
cue or loop points cannot be performed
because there are no data in the RAM
buffer just after the recall operation.
Once playing from cue points (CUE 1-3)
and/or loop start point for a few second,
flash start and/or seamless looping can
be performed.
4-6. Fader Start
Connect the FADER START jack on the rear panel
of the main unit and fader start jack on the external
device which supports the fader start function (i.e.
X-9, X-17, X-15, XS-3, etc...) with the fader start
cable which is supplied to perform fader start/back
cue performance with external device.
Audio signal should be connected to the external
device as well.
TIP: Start (low active, more than 50ms)
GND: Back cue (low active, more than 50ms)
4-7. Relay Play
Turning on the Relay play function either left or
right unit turns on the relay play function. When
relay play is activated, when left unit finishes
playback, right unit will start playback and vice
versa automatically.
Pressing and holding the SHIFT key then pressing
the BRAKE key turns the relay play function on
and off.
When relay play is turned on, the
"RELAY" indicator in the LCD lights.
4-8. Auto Cue
Auto cue function allows the unit to search the
beginning of the song and pause there
automatically.
The detection level is fixed to
–54dB. When Auto cue function is turned on,
"A.CUE" indicator in the LCD lights.
Pressing and holding the SHIFT key then pressing
the BEND – key turns the AUTO CUE function on
and off.
4-9. Auto Ready
Auto Ready function allows the unit to pause the
beginning of the next track when playback of the
current track is finished.
The behavior of Auto Ready function is follows.
Continuous play mode:
Pause the beginning of the next track when
playback of the current track is finished.
Single play mode:
Pause the beginning of the current track when
playback of the current track is finished.
Program play mode:
Pause the beginning of the next programmed
track when playback of the current track is
finished.
When Auto Ready function is turned on, "A.RDY"
indicator in the LCD lights.
Pressing and holding the SHIFT key then pressing
the BEND + key turns the AUTO READY
function on and off.
TASCAM CD-X1500 DUAL CD PLAYER
English
17
Capítulos
Tabla de contenido
