Idiomas disponibles
Idiomas disponibles
Assemble The Unique Components Of The Deluxe Engine
Install The Oil Shield
1. Install the oil shield into the lifter valley. See Figure 12.
2. Ensure the shield snaps into place. See View A in Figure 12.
FIGURE 12
CYLINDER HEAD ASSEMBLY
VIEW A
TYPICAL BOTH SIDES
Install The Intake Manifold Gaskets
1. Place the intake gaskets with the part number side facing up on the cylinder heads. The three cutouts for the oil shield will
be on the bottom of the gasket. Verify that the gaskets do not obstruct the port openings of the cylinder heads. No trimming
should be necessary on the gaskets. However, if some trimming is necessary mark the parts of the gaskets that need trimming.
Remove the gaskets from the heads. Trim the gaskets with an utility knife. Place the gaskets on the intake manifold with the
part number side facing the manifold. Verify that the gaskets do not obstruct the port openings of the manifold. If necessary,
trim the gaskets with an utility knife. Install the gaskets on the heads with the part number side facing up. Slide the oil shield
forwards or backwards to ensure that the cutouts in the gaskets fit around the tabs on the oil shield. See Figure 13.
2. Do not use end seals across the end seal surface of the engine block. Instead apply a 3/8" bead of RTV sealer. Overlap the
four corners of the intake gaskets with the sealer. See View A in Figure 13.
INTAKE MANIFOLD
GASKET
FRONT
BLOCK
ASSEMBLY
SEALER
502/502 Big Block Chevrolet Engine Pkg.
TITLE
SHIELD
ALL GASKET MATING
SURFACES TO BE FREE OF
OIL AND FOREIGN MATERIAL
CYLINDER HEAD ASSEMBLY
FRONT A
CYLINDER HEAD
ASSEMBLY
A
CYLINDER HEAD
FIGURE 13
12368083
REV 16JA15
PART NO.
SHIELD
CYLINDER HEAD
ASSEMBLY
GASKET
VIEW A
TYPICAL FOUR CORNERS
SHEET
SEALER
7
63
OF
