Stove Installation - Dimplex DS5629 Manual De Instrucciones

Stove Installation

!
NOTE: a 15amp, 120
volt circuit is required. a
dedicated circuit is preferred
but not essential in all cases. a
dedicated circuit will be required
if, after installation, the circuit
breaker trips or fuse blows on a
regular basis when the heater is
operating. additional appliances
on the same circuit may exceed
the current rating of the circuit
breaker.
 W ARNINg: Ensure the power
cord is not installed so that
it is pinched or against a
sharp edge and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
fire, electric shock or injury to
persons.
Construction and electrical
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your
own new outlets or circuits. To
reduce the risk of fire, electric
shock or injury to persons,
always use a licensed electri-
cian.
1. Make sure the units on/off
switch is switched oFF (refer
to operating instruction sec-
tion).
2. Plug the unit into a
15amp/120volt outlet.
7