Black+Decker WW100 Manual De Instrucciones página 4

ENGLISH
Electrical safety
Your charger has been designed for a specific voltage. Always
check that the mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the charger unit with
a regular mains plug.
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the adapter
unit with a regular mains plug.
Symbols on Charger
Short circuit proof safety isolating transformer.
SMPS
$
The charging base is intended for indoor use
only.
+
Labels on appliance
Read all of this manual carefully before
using the appliance
Only use with charger SSA-6P-05
SSA-6P-05
LED Patterns Charging
LED Patterns In use
Battery diagnostics
If the appliance detects a weak battery, the charging indicator
will flash at a fast rate when the power button is activated.
Proceed as follows:
Plug in the charger. Switch on at the mains.
u
Leave the appliance to charge.
u
4
(Original instructions)
Charging
Battery Fault
Battery low
Battery Empty
If the appliance detects a damaged battery, the charging
indicator will flash at a fast rate when the appliance is on
charge. Proceed as follows:
Take the appliance and the charger to be tested at an
u
authorised services centre.
Note: It may take as long as 60 minutes to determine that
the battery is defective. If the battery is too hot or too
cold, the LED will alternately blink, fast and slow, one
flash at each speed and repeat.