Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, or SG rated SAE 10W-30 weight.
Other viscosity oils shown in the chart may be used
when the average temperature in your area is within
the recommended range.
•
Place pressure washer on a level surface.
•
Clean area around oil fill, remove oil dipstick and
wipe it clean.
•
Slowly pour oil into oil fill opening until oil reaches
"UPPER LIMIT" mark on the dipstick. Stop
occasionally to check oil level. Insert and remove
the dipstick without screwing it into the filler neck.
•
If the oil level is near or below the lower limit mark
on the dipstick, fill with the recommended oil to the
upper limit mark. DO NOT OVERFILL.
•
Install oil dipstick, hand tighten securely.
NOTE: Check oil often during engine break–in.
Add Gasoline
DANGER!
Never fill fuel tank indoors. Never
fill fuel tank when engine is running or hot. Do
Not smoke when filling fuel tank.
WARNING!
Never fill fuel tank completely full.
Provide space for fuel expansion. Wipe away
any fuel spillage from engine and equipment
before starting.
Use fresh, clean unleaded automotive gasoline.
•
Use clean fuel and store in approved, clean,
covered containers. Use clean fill funnels. Never
use "stale" gasoline left over from last season or
gasoline stored for long periods.
•
Clean area around fuel fill cap, remove cap.
•
Slowly add gasoline to fuel tank. Use a funnel to
prevent spillage. Fill tank to "Fuel Level Mark" as
shown below.
•
Install fuel cap and wipe up any spilled gasoline.
5
Capítulos
Tabla de contenido
