Operating Conditions; Warranty - Hameg Instruments HZ530 Manual Del Usuario

Operating Conditions

Warranty

Änderungen vorbehalten / Reservado el derecho de modificación
The probes have been designed for indoor use. The permissible
ambient temperature range during operation is +10°C (+50°F) ...
+40°C (+104°F). It may occa sionally be subjected to temper atures
between +10°C (+50°F) and -10°C (+14°F) without degrading its
safety. The permissible ambient tem perature range for storage or
trans portation is -40°C (+14°F) ... +70°C (+158°F).
The maximum relative humidity is up to 80%.
If condensed water exists in a probe it should be acclimatized before
switching on. In some cases (e.g. probe extremely cold) two hours
should be allowed before the probe is put into operation.
Specifications: Values without tolerances are typical for an
average instrument.
HAMEG instruments are subjected to a rigorous quality control. Prior
to shipment each instrument will be burnt in for 10 hours. Intermit-
tent operation will produce nearly all early failures. After burn in, a
final functional and quality test is performed to check all operating
modes and fulfilment of specifications. The latter is performed
with test equipment traceable to national measurement standards.
Statutory warranty regulations apply in the country where the HA-
MEG product was purchased. In case of complaints please contact
the dealer who supplied your HAMEG product.
29