Important Hints; Safety - Hameg Instruments HZ530 Manual Del Usuario

Important Hints

Symbols

Safety

28
Users are advised to read through these instructions so that all func-
tions are understood. Immediately after unpacking, the instrument
should be checked for mechanical damage and loose parts in the
interior. If there is transport damage, the supplier must be informed
immediately. The probes must then not be put into operation.
ATTENTION - refer to manual
Danger - High voltage
Protective ground (earth) terminal
The probes have been designed and tested in accor dance with IEC
Publication 1010-1, Safety require ments for electrical equipment
for measurement, control, and laboratory use. The CENELEC
regulations EN 61010-1 correspond to this standard. They have left
the factory in a safe condition. This instruction manual contains
important information and warnings which have to be followed
by the user to ensure safe operation and to retain the probes in a
safe condition.
Whenever it is likely that protection has been impaired, the in-
strument shall be made inoperative and be secured against any
unintended operation. The protection is likely to be impaired if, for
example, the instrument
• shows visible damage,
• fails to perform the intended measurements,
• has been subjected to prolonged storage under unfavourable
con ditions (e.g. in the open or in moist environments),
• has been subject to severe transport stress
(e.g. in poor packaging).
Änderungen vorbehalten / Subject to change without notice