Operation; Changing The Channel Selection - Sony WRT-860A Manual De Instrucciones

Operation

Changing the Channel Selection

The example shows TV channel display on the WRT-860A(68).
DISPLAY
1
POWER
3
1
While holding down the SET/DISPLAY button, set the
POWER switch to ON.
Hold the SET/DISPLAY button down until a display
appears.
The transmitter goes to setting mode and the indication
on the liquid-crystal display flashes.
If the channel or time-of-use indication had been
selected before the transmitter was previously turned
OFF, the channel indication flashes (channel number
selection mode). If the frequency had been selected, the
frequency indication flashes (frequency selection mode).
+
2
–
You can change the channel selection either by channel
number or frequency. Each time you press the SET/
DISPLAY button, channel number selection mode,
attenuator adjustment mode (page 15) and frequency
selection mode are cyclically switched.
Channel number selection mode
AF RF BATT
ATT CH
2
Press the + or – button to select the channel.
Pressing the + button cyclically changes the channel in
the listed order in the table of "Channels and Carrier
Frequencies" on page 6, 7, or 8. Pressing the – button
changes it in the reverse order.
Channel number selection mode
ATT CH
+ button
– button
ATT CH
Frequency selection mode
AF RF BATT
ATT CH
Frequency selection mode
ATT CH
+ button – button
ATT CH
(Continued)
13