Trigger Mode; Tig Mode - GYS EXATIG HF Manual De Instrucciones

MADE IN FRANCE
SELECT IGNITION MODE
HF TIG: High Frequency start without contact
TIG LIFT : Arcing by contact (for environments where HF is not desirable). (only usable with EXAGON)
Touch Switch
Pré Gaz 0.5s
COMPATIBLE TORCHES
L
The remote control and foot pedal command features are not available when EXATIG is connected to EXAGON and are automatically deactivated.
DB

TRIGGER MODE

2T mode
P
t
Main button T1
4T mode
t
T1 T2
Main button

TIG MODE

The chronogram for TIG is as shown in the table below:
EXATIG HF
Lift
1- Touch the workpiece with the electrode
2- Press the trigger on the torch
3- Pull back the torch to lift the electrode.
<1s
L
DB
P
t
T2
t
T4
T3
L
DB
P
T1 - The main button is pressed, the welding cycle starts (PreGas and
welding).
T2 - The main button is released, the welding cycle is stopped (Pos-
tGas)
For the double button torch and in 2T mode only, the secondary button
works like the main button..
T1 - The main button is pressed, welding cycle starts at PreGas and
stops in the I_Start.
T2 - The main button is released, the cycle continues in UpSlope and in
welding.
T3 - The main button is pressed, the cycle switches to DownSlope and
stops in I_Stop.
T4 - The main button is released, the cycle ends with PostGas.
EN
19