Astralpool OPTIMA PLUS Manual De Instalación página 7

Display during Operation
•
Setpoint type;
Acid/Alka
Alarms and statuses
• Cal = calibration not
completed
• Lev = Level alarm
• Flw = Flow alarm
• Alm = Measurement
outside Alarm Band
• OFA = O.F.A. alarm
Paragraph 2 – Dosage Proportional to the Potential Redox Measurement (O.R.P.)
Programming
PROG
Configuration
Pump Funtions
-
+
Pump
Functions
Redox Measure
Setpoint
560 mV
-
Setpoint Type
High
-
Prop. Band
50 mV -
Alarm Band
200 mV -
O.F.Alarm
0m
-
Probe Calib.
On
-
Display during Operation
•
Setpoint type;
High/Low
Alarms and statuses
• Cal = calibration not
completed
• Lev = Level alarm
• Flw = Flow alarm
• Alm = Measurement
outside alarm band
• OFA = O.F.A. alarm
EM00136408
Flow sensor status
F F F
Alca 7.00pH
Lev Stop P100%
Pump status
•
Empty = pump in start
•
Stop = pump stationary
•
Paus = pump in pause
The pump measures and controls the pH of a solution, programming in
sequence: set-point, set-point type, proportional band and alarm band
Set-point type: maximum
max
flow-rate
- Set-point type: minimum
+
-
+
max
flow-rate
-
+
-
+
-
+
It is also possible to programme:
- the O.F.A. (Over Feed Alarm) time in minutes, or rather a time beyond which an
-
alarm signal is triggered if the pH value does not reach the set-point.
+
- The measurement resolution (1 or 2 decimal points)
- Deactivation/activation of the calibration procedure
The maximum frequency can be modified during operation, by pressing
the
keys to decrease it.
Flow sensor status
High F F F 560mV
Lev Stop P100%
Pump status
•
Empty = pump in start
•
Stop = pump stationary
•
Paus = pump in pause
pH measurement value
Current dosage value
(depends on the selected unit
of measurement)
•
Percentage, Frequency,
l/h, Gph, ml/m
s/m
Pump Off
0
Alarm Band
s/m
Proportional
0
Alarm Band
keys at the same time to increase the flow, or the
Potential Redox.
measurement value
Current dosage value
(depends on the selected unit
of measurement)
•
Percentage, Frequency,
l/h, Gph, ml/m
rev. 1.0
Display during Setting (MODE key)
Displays in sequence
•
SP = Setpoint value
•
BP = Proportional band value
•
BA = Alarm band value
•
OFA = O.F.A. value
•
Temp = Temperature value
SP
7.00pH
4.50pH P100%
Maximum set dosage value
(depends on the selected unit of measurement)
•
Percentage, Frequency, l/h, Gph, ml/m
Operation
Proportional
Band
Alarm Band
Band
Pump Off
Alarm Band
Display during Setting (MODE key)
Displays in sequence
•
SP = Setpoint value
•
BP = Proportional band value
•
BA = Alarm band value
•
OFA = O.F.A. value
SP 560mV
450mV P100%
Maximum set dosage value
(depends on the selected unit of measurement)
•
Percentage, Frequency, l/h, Gph, ml/m
Measurement value
mV
mV
Measurement value
della misura.
5