Bosch DAF220 Miterfinder Manual Original página 11

daf220_bu_2609140572_003.fm Seite 12 Montag, 8. September 2008 2:22 14
12 |
HOLD (Memory)
The hold memory is a single-value
memory that is useful for several
purposes:
– For storing a specific angle value
will be used repeatedly in com-
pound cut calculations, such as
the common 38° crown molding
spring angle.
– For storing an angle measured in
a confined situation ...
when the display cannot be
seen when the measurement
is taken and
when it is necessary to fold
the leg to move the tool so
that the display can be seen.
(For example, when measur-
ing the angle of eaves from an
attic.)
Procedure
To store an angle in the HOLD
memory,
– Press the RECALL/HOLD button
5 for more than 1 second.
– The display and HOLD indicator g
blink twice of to confirm the suc-
cessful storage of the angle.
To recall the stored angle, simply
press the RECALL/HOLD button 5
for less than 1 second. The recalled
angle then flashes in the display.
Notes:
– The tool maintains the stored
angle even after the tool is shut-
off manually or automatically.
– However, if the battery power is
exhausted or when the batteries
are removed, the stored angle
will be lost and need to be re-
stored after new batteries are in-
stalled.
– If the HOLD button is pressed
for more than 1 second when
0.0° is the displayed angle, any
stored angle is deleted.
2 609 140 572 | (8.9.08) Bosch Power Tools