Memory - Displaying The Last 120 Measurements; Discontinuing A Measurement - Microlife BP3NQ1-4X Manual De Instruccion

5.7. Memory – Displaying the last 120 Measurements
t the end of a measurement, this monitor automatically stores each result with date
and time. This unit stores 120 memories for each of 2 users.
Viewing the stored values
With the unit off, press the "M" button. The display first shows " ", then shows an
average of all measurements stored in the unit. Please note: Measurements for
each user are averaged and stored separately. Be certain that you are view-
ing the measurements for the correct user.
Pressing the "M" button again displays the previous value. To view a particular stored
memory, press and hold the "M" button to scroll to that stored reading.
Memory full
When the memory has stored 120 results a new measured value is stored by over-
writing the oldest value.
Clear all values
If you are sure that you want to permanently remove all stored val-
ues, hold down the "M" button (the instrument must have been
switched off beforehand) until "CL" appears and then release the
button. If you do not want to clear the values, press the
ST RT/STOP button. To permanently clear the memory, press the
"M" button while "CL" is flashing.
Individual values cannot be cleared.
1

5.8. Discontinuing a Measurement

If it is necessary to interrupt a blood pressure measurement for any
reason (e.g the patient feels unwell), the ST RT/STOP button can
be pressed at any time. The device then immediately lowers the
cuff pressure automatically.
13