Glossary - Gemini GEM-P400 Manul De Operacion

Ambush Code - In the event that you
are forced by an intruder to disarm your
system, this special code can be used to
disarm the system, and simultaneously
send a silent alarm to Central Station. If
your system has the Ambush feature
enabled, the code assigned as the User
4 code will function as your Ambush
Code.
Arming / Disarming - Turning the
system on or off by entering your user
code at the keypad, followed by
Auto Interior Bypass - A feature which
allows the system to recognize when you
have not left the premises and automati-
cally bypass any interior zones, deacti-
vating devices such as motion sensors,
allowing free movement throughout the
premises.
Battery - A backup source of power to
provide protection for a limited time in

the event of a power failure.
Bypass - the manual or automatic re-
moval of one or more protection zones
from the system. Press
the zone number to bypass a zone.
14
Oi230a
page 14
Central Station - Monitors
emergency and trouble reports from the
alarm system and notifies proper authori-
ties.
Chime - a keypad beep which indicates
that a door has been opened while the
system is disarmed.

Easy Exit - Allows an occupant to leave
the premises without disarming the sys-
tem. Pressing
.
while the system is armed will permit exit
by removing the protection on the Exit/
Entry door for 3 minutes.
Exit/Entry Delay - The amount of time
you are allowed to enter and leave the
premises when the system is armed.
Exit/Entry Zone - A zone which will
allow you to enter and leave the
premises when the system is armed.

Instant Protection - Arming without En-
try Delay while remaining on the
premises. (Press
and then
alarm, Keypad Sounder - A local warning de-
vice at the keypad to alert that Entry
delay has started,

System Trouble - A problem has been
detected in the system which may pre-
vent it from working properly.
TROUBLE

tem trouble.
User Code - A four digit code which is
and then
used to arm and disarm the system from
the keypad.
User 1 Code - A four digit code which
can be used to program,
and erase user codes, as well as arm
and disarm the system from the keypad.
Zone - An area which is protected by a
security device. Your front door may be
designated as Zone 1, while the living
room motion detector may be Zone 2.
Refer to the Zone Label on your keypad
for the Zone Identification of your sys-
tem.
while armed)

Glossary

will be lit to indicate a sys-
re-program
Tuesday, September 16, 1997 08:26