Adapter Plugs - Gemini GEM-P400 Manul De Operacion

IMPORTANT SAFETY INSTRUCTIONS.
READ ALL INSTRUCTIONS BEFORE USING.

ADAPTER PLUGS

Usage situations where appliance's power cord will be disconnected infrequently.
Because of potential safety hazards under certain conditions,
we strongly recommend against the use of an adapter
plug. However, if you still elect to use an adapter, where
local codes permit, a TEMPORARY CONNECTION may be
made to a properly grounded wall receptacle by the use of a
UL listed adapter which is available at most local hardware
stores.
The larger slot in the adapter must be aligned with the larger
slot in the wall receptacle to provide proper polarity in the
connection of the power cord.
CAUTION: Attaching the adapter ground terminal to the wall receptacle cover screw does
not ground the appliance unless the cover screw is metal, and not insulated, and the wall
receptacle is grounded through the house wiring.
You should have the circuit checked by a qualified electrician to make sure the receptacle
is properly grounded.
When disconnecting the power cord from the adapter, always hold the adapter with one
hand. If this is not done, the adapter ground terminal is very likely to break with repeated
use. Should this happen, DO NOT USE the appliance until a proper ground has again been
established.
Usage situations where appliance's power cord will be disconnected frequently.
Do not use an adapter plug in these situations because frequent disconnection of the
power cord places undue strain on the adapter and leads to eventual failure of the
adapter ground terminal. You should have the 2-prong wall receptacle replaced with a
3-prong (grounding) receptacle by a qualified electrician before using the appliance.
PACEMAKERS
Most pacemakers are shielded from interference from electronic products, including
microwaves. However, patients with pacemakers may wish to consult their
physicians if they have concerns.
READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.
SAVE THESE INSTRUCTIONS
14
(Adapter plugs not
permitted in Canada)
Align large
prongs/slots
Ensure proper
TEMPORARY
ground and
METHOD
firm connection
before use.