Worx WX800 Manual Original página 11

ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING! To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Help to minimize your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
WX800
Metal
1
grinding disc
Wheel guard
1
for grinding
Spanner 1
Auxiliary
1
handle
Battery pack 2(WA3551.1)
Charger 1(WA3860)
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting metal, a special protection guard
for cutting (accessory) must be used.
Lithium-Ion cordless angle grinder
WX800.2 WX800.9
1 1
1 1
1 1
1 1
1(WA3641) /
1(WA3860) /
ASSEMBLY AND OPERATION
Action
BEFORE OPERATION
Removing the battery pack
Charging the battery pack
Installing the battery pack
WARNING: When
replacing the battery
pack, do not insert the
battery until the Grinding/
Cutting Disc comes to a
complete stop!
ASSEMBLY
Assembling Auxiliary Handle
Assembling Grinding/Cutting
Disc
Adjusting Wheel Guard
NOTE: Before any work on
the machine itself, remove
the battery pack. For work
with grinding or cutting
discs, the protection guard
must be mounted. Use the
correct type of disc for your
application. If the power
tool is intended to perform
cutting off operations,
a guard specific for this
operation must be fitted.
The coded projection on the
wheel guard ensures that only a
guard that fits the machine type
can be mounted.
Open the clamping lever (13).
Place the wheel guard with
coded projection into the coded
groove on the spindle of the
machine head and rotate to
the required position (working
position).
To fasten the wheel guard, close
the clamping lever (13).
The closed side of the
wheel guard must always
point to the operator.
OPERATION
Using On/Off Switch
Hand Grip Areas
Rough Grinding
WARNING! Never use a
cutting disc for
roughing.
Cutting
Figure
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B
See Fig. C1,
C2, C3
11
See Fig. D
See Fig. E
See Fig. F
See Fig. G
EN