Worx WX178 Traducción De Las Instrucciones Originales página 11

Bit Lock Adjustment
TM
The Bit Lock switch (12) equipped in this tool can
TM
release or grab a bit very quickly and automatically.
This can be realized by rotating the Bit Lock
clockwise or counterclockwise.
WARNING: Always ensure the bit is secure
before starting the tool. Damage to the Chuck
or a loose bit may cause possible personal injury.
NOTE: When the chuck jaws become fully opened
or closed, the clutch will activate, making a clicking
sound. This sound is normal.
If the Bit Lock Switch (12) does not operate, confirm
TM
the battery is charged and depress the trigger briefly.
Keep drill tilted upward when adjusting the chuck to
prevent bit from falling out.
Forward/Reverse Rotation Switch
WARNING: Never change
the direction of rotation
when the Chuck is rotating. Wait
until it has stopped!
Function Mode Selection
Press the function button to select operation mode.
The button will illuminate in blue for a few seconds.
Depress the Variable Speed Switch (10) slightly to
illuminate the function button again.
Drive Mode with Safe drive
•When driving a screw, the tool
will automatically stop as the
screw head becomes flush with
surface of workpiece. If a deeper
screw is desired, continue to
depress the Variable Speed
Switch (10). The tool will make
slow rotations to drive the screw
deeper.
• Once the desired depth is
reached, please release the
Variable Speed Switch (10).
NOTE:
1. If the tool stops sooner than
desired, release the Variable Speed
Switch (10) and press it again.
2. Safe drive function cannot
TM
be activated unless the variable
speed switch (10) has achieved the
maximum speed.
Drill Mode
Lithium-Ion Cordless Drill/Driver
ring
TM
See Fig. D1,
D2, D3
TM
See Fig. E
See Fig. F
Pulse Assist
WARNING: Do not work for
long periods with the Pulse
Assist activated as the motor can
be overheated.
NOTE: Pulse Assist is very
effective to prevent stripping
screws, removing stubborn screws
and to prevent the bit tip from
walking when drilling on smooth
surfaces. When the Pulse Assist is
activated, it can be switched with
the drill/drive mode.
• Make sure the Forward/Reverse
Rotation Switch (4) is pushed
to the left or right and the Pulse
Assist is selected.
• Press the Variable Speed Switch
(10), the tool will begin to rotate at
a controllable pace.
Variable Speed Switch
WARNING: Do not operate
for long periods at low
speed because excess heat will be
produced internally.
See Fig. G
See Fig. H
11
EN