Fermax 94891EIc Manual De Instrucciones página 73

VERY IMPORTANT NOTES
* The system assigns a set talking time, (between 15 and 45 seconds) during
which the conversation cannot be interrupted. Once this time is up, any other
call will cut off the communication in course.
In any case, after a maximum time, also programmed in the system (between
30 and 250 seconds), the call will also be cut off. Ask the maintenance staff
what talking time and maximum time have been assigned, or get them
modified if necessary.
* In residential facilities with several blocks or sectors, with the aim of
differentiating the telephone numbers, which will be repeated, the long call
mode is used, where in order to call a telephone it is necessary to previously
indicate the block number and then the telephone number, with 4 digits.
The block number will come on screen, followed by the telephone number:
b b - t t t t, instead of telephone only: t t t t.
Example: You want to call telephone nº 23 in block 5
NOTE: The telephone number, panel numbers, block numbers and Guard
Unit numbers were programmed during installation of the system. Please
contact the maintenance staff for further details.
1. Enter the block number followed by the telephone
number.
For the telephone number, you must always enter
4 digits.
The number to dial would then be 50023.
2. Press the BELL key to call.
The display indicates GUARD UNIT-TELEPHONE
communication, and the block number (05) of the
telephone called.
[
01/05 0023
]
Pag 27