Honeywell HZ-605 Serie Manual De Instrucciones página 4

HZ-680 SERIES OPERATION
• With the power switches in the OFF position, plug the heater into a 120V outlet.
• Never leave an operating unit unattended.
• Turn the thermostat control fully clockwise to its highest setting.
• This heater has 3 levels of heating. Press I for Low setting. Press II for Medium setting and press
both I and II for the High setting (Fig. 4a: l for 600W/LOW, Fig. 4b: ll for 900W/MED, or Fig.
4c: III for 1500W/HIGH). You can select the proper setting to accommodate your comfort level.
Because the Low and Medium heat settings do not require as much electricity to operate, they
are more energy efficient and may be better options if you are concerned about the amperage
draw on a circuit when the heater is in the High setting.
• Turn the power switches to ON. They will illuminate, and the heater is now in use.
• When the room reaches a comfortable temperature, slowly turn the adjustable thermostat
knob counter-clockwise until the heater goes off. This is the point where the thermostat
setting equals the room temperature. At this setting, the
thermostat will automatically maintain your desired room
temperature by cycling the heater on and off. The power
indicator will remain on when the unit is cycling on and off.
Just the heating element will actually turn on and off.
• Turning the thermostat clockwise will always increase the
"set" temperature; turning the thermostat counter-clockwise
will decrease the "set" temperature.
• Turn the power switches to OFF ( ) and unplug heater when
finished using the heater.
NOTE: THIS HEATER WILL COOL DOWN SLOWLY AFTER THE POWER IS SHUT OFF. BEFORE MOVING THE HEATER USING THE
BUILT IN HANDLE, ALLOW THE HEATER TO COOL.
HZ-605 SERIES/HZ-690 SERIES OPERATION
• With the power control knob in the OFF ( ) position, plug the heater into
a 120V outlet.
• Never leave an operating unit unattended.
• Turn the heater ON by turning the power control knob clockwise to the desired
position. The power light will illuminate. Turning the unit on High and leaving the
unit on this setting for approximately 1 hour will speed up the heat output.
• You can then select the proper setting to accommodate your comfort level. This
heater is equipped with three different heat settings (Fig. 5).
The HZ-690 Series, the Low setting ( ) uses 600 watts of power, the Medium
setting ( ) uses 900 watts of power and the High setting (
of power.
The HZ-605 Series uses 400 Watts of power on the Low setting ( ), 600 watts
of power on the Medium setting( ) and 1000 watts of power on the High
setting ( ).
• Turn the thermostat control fully clockwise to its highest setting.
• Because the Low and Medium heat settings do not require as much electricity
to operate, they are more energy efficient and may be better options if you are
concerned about the amperage draw on a circuit when the heater is in the
High setting.
4
Fig. 4b
Fig. 5
Power
Control
Power
Indicator
Light
) uses 1500 watts
Adjustable
Thermostat
Fig. 4a
Adjustable
Thermostat
Power
Level
Switches
Fig. 4c