Stanley ST-80T-KFA Manual De Instrucciones página 5

NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE
FEATURES
Upper Shell
Hot Air Outlet
Lower Shell
Lamp
Thermostat Knob
Power/Reset Switch
ASSEMBLY INSTRUCTIONS (140T-KFA / 215T-KFA)
1. Insert axle through holes in wheel support.
2. Slide spacer onto axle.
3. Slide wheel onto axle and hold in place with the axle
nuts (see Figure 1).
4. Place heater on wheel support and line up holes on the
fuel tank lip.
5. Attach front handle with (2) long screws (50 mm) and
(2) nuts through the second hole from the front on
both sides of the tank lip and wheel support frame and
tighten firmly.
6. Insert (2) short screws (30 mm) through the first hole
from the front in the tank lip and tighten firmly. Make
certain all (4) screws are secure.
7. Attach rear handle with (2) long screws
(50 mm) and (2) nuts through the second hole from the
rear of the heater on either side (see Figure 2).
Wheel Support Frame
Tire
Axle Nut
Extension Cord Wrap
Handle
Fan Guard
Pressure Gauge
Fuel Gauge
Fuel Cap
Fuel Tank
Hot Air
Power Cord
Outlet
Lower Shell
Fuel Gauge
Fuel Cap
Spacer
Kerosene Foreced Air Heater (ST-80T-KFA/ST-140T-KFA/ST-215T-KFA)
Front
Handle
Upper Shell
Lamp
Thermostat
8. Tilt the heater up gently so it is resting on the front
handle.
NOTE: DO NOT do this if there is fuel in the tank.
9. Remove the wheels to secure the second set of screws
through the rear handle.
10. Secure the rear handle with (2) short screws (30 mm)
and (2) nuts and tighten firmly.
11. Replace wheels and tighten with the wheel nuts.
12. Tilt heater back down onto wheels and check all screws
and nuts to ensure they are secure.
Axle
Figure 1
Rear Handle
Digital Temperature
Display
Knob
Power
Cord
Figure 2
ENGLISH
Fan Guard
Pressure
Gauge
Fuel Tank
Drain Bolt
4