Description Of Symbols - Silverline Fall Arrest Kit Manual De Instrucciones

GB
Safety Guide

Description of Symbols

Wear hearing protection
Wear eye protection
Wear breathing protection
Wear head protection
Read instruction manual
1105
For Declaration of Conformity please visit www.silverlinetools.com
2
255234_SafetySheet.indd 2
Inspection & Pre-use Checks
A thorough visual inspection should be carried out on all products before use. This inspection should
Caution!
include (but is not limited to) the following:
• Check all webbing for signs of cuts, abrasions, fraying, tears, burns, mould, discolouration or
chemical attack
• Check all stitching for signs of loose threads, pulling or cuts. Stitch pattern must be identical on
Conforms to relevant legislation
both sides
and safety standards.
WARNING: If the pattern is not visible because of paint etc, DO NOT USE.
Notified body number
• Buckles and D-rings must be free from rust, distortion, excessive wear or cracks
• Lanyards must be no longer than 2m
Note: If, during inspection, any part of the fall arrest system is deemed to be faulty, it must be
removed from service and destroyed. Repairs, modifications or alterations must not be carried out on
any of these products.
Note: All Silverline harnesses and lanyards are designed to arrest a fall from height ONCE ONLY.
MIN =
WARNING: If the harness/lanyard has been subjected to a fall arrest then it must be removed
6.5m
from service immediately and destroyed.
Maintenance, Cleaning & Storage
• Silverline harnesses, lanyards and work positioning belts should be stored in their original
packaging away from sources of humidity, sunlight and direct heat
• Webbing products may be cleaned in water not exceeding 40°C, using a mild,
pH-neutral detergent
• Allow the product to dry naturally before storage (DO NOT force dry)
Rescue Plan
• As part of the risk assessment you MUST have in place a rescue plan before working at height, to
deal with any emergency that may arise
09/12/2019 16:17