Tabla de contenido
Idiomas disponibles
Idiomas disponibles
IMPORTANT: It is important to prevent gum deposits
from forming in essential fuel system parts such as the
carburetor, fuel filter hose or tank during storage. Also,
experience indicates that alcohol-blended
fuels (called
gasohol or using ethanol or methanol) can attract mois-
ture which leads to separation and formation of acids
during storage. Acidic gas can damage the fuel system
of an engine while in storage. To avoid engine problems,
the fuel system should be emptied before storage of 30
days or longer. Never use engine or carburetor cleaner
products in the fuel tank or permanent damage may
Occur.
NOTE: Never start pressure washer without water
source turned on and connected to pressure washer.
To Start
Your Pressure
Washer
Make sure fuel shutoff valve is turned to the open
position. Turn couner-clockwise
to open,
• Remove gas cap.
• Add unleaded gasoline, slowly, to fuel tank.
• Do not overfill.
• Squeeze trigger on pressure washer wand to relieve air
pressure caused by turning on the water. Water will
spew out of the gun in a thin stream. This will make it
easier to start the engine.
• Engage the safety latch on the spray gun. This locks
the trigger in place and keeps you from accidentally
spraying a high pressure stream.
SAFETY
I_ATCH
• On the engine there is a choke/run
lever. Place lever
to the choke position.
• On the engine there is a throttle control lever. Place
throttle to the rabbit position. Always start engine
with throttle in the rabbit position,
• Connect garden hose to the water inlet on the
pressure washer. Tigthen by turning water inlet
counterclockwise.
• Connect
high pressure hose to discharge on pump.
• Connect the garden hose to the water spout
and turn water supply on.
• Grasp the starter grip and pull slowly until resistance
is felt, then pull firmly to start engine.
• Grasp the starter grip and pull slowly until resistance
is felt, then pull firmly to start engine.
• When engine starts, gradually move choke lever to
RUN position.
• If engine does not start after 5 pulls, place choke back
to run postion,
• For hot engine starts make sure choke lever is in the
run positon. Make sure fuel shut off valve is open and
throttle is in the rabbit position.
NOTE." If any leaks are present shut unit down and
tighten fittings,
10
Tabla de contenido
