Motorola RVA50UL Manual Del Usuario página 37

codes pool. For example, if you try to program
code 220, the radio would not accept it as the
maximum value allowed is 219. Same goes for
the frequencies. Refer to the"Frequency and
Code Charts" on page 54 to make sure you are
programming a valid value.
3. I am trying to enter the Programming Mode but
the radio would not do it.
The radio may be locked using the CPS to
disallow Front Panel Programming. To re-
enable, use the CPS.
4. I programmed the wrong value when I was
programming. How can I erase or re-program
the value?
If you programmed the wrong value, you can
either:
• 'Roll-over' the radio. The radio 'roll-over' each
time it reaches the maximum value allowed. Keep
increasing (short press the SB1 button) or
decreasing (short press the SB2 button) until you
get the desired value or,
• Turn OFF the radio and start over.
5. I just programmed the value I wanted. How do I
exit the Programming Mode?
You can either:
• long press the PTT button twice to exit if you're in
the Programming Mode or,
• Long press the PTT button once if you are
already in the 'Idle' Programming mode.
6. I am done programming the features in this
channel. How do I program another channel?
Short press the PTT button several times until
you hear "Channel Number". Switch channel by
rotating the Channel Selector Knob. If you wish
to save the changes, make sure you are in the
'Idle' Programming Mode before switching the
channel, otherwise you will lose the changes
made.
35
English