LG DLEX9000 Serie Manual Del Usuario página 48

48
TROUBLESHOOTING
Before Calling for Service (cont.)
Drying time is
not c onsistent dampness of clothing is not
consistent.
Clothes take
too long to dry
properly.
duct run is too long.
breaker has tripped, or power
outage has occurred.
Energy Saver option selected
Clothes are
wrinkled (overdried).
after cycle ends.
Clothes are
shrinking not being followed.
indicator
light is on
during the
drying cycle
Water drips
from nozzle
when Steam
Cycle starts
The display
shows "d90", 95% blocked.("d90" or "d95" error
"d95" code displayed 2 hours only)
The drying time for a load will vary depending on the heat
setting, the type of heat used (electric, natural gas, or LP gas),
the size of the load, the type of fabrics, the wetness of the
clothes, and the condition of the exhaust ducts and lint filter.
heavier items take longer to dry.
retain more moisture. To help reduce and maintain more
consistent drying times for large and heavy fabrics,
separate these items into smaller loads of a consistent size.
you are drying.
some loads that produce high amounts of lint, it may be
necessary to clean the filter during the cycle.
and free of debris, lint, and obstructions. Make sure that
outside wall dampers can open properly and are not
blocked, jammed, or damaged.
fuse capacity. If the problem is a circuit overload, have it
corrected by a qualified electrician.
ensure proper tumbling action.
If using the Cotton/Normal cycle, deselect the Energy Saver
option. This option reduces energy use by adding an air dry
section to the beginning of the cycle.
Try a shorter drying time, and remove items while they
still retain a slight amount of moisture.
tumbling clothes at the end of the cycle, for up to 3 hours.
To avoid shrinkage, please carefully follow the fabric care
instructions for your garment, because some fabrics will
naturally shrink when washed. Other fabrics can be washed but
will shrink when dried in a dryer. Use a low or no heat setting.
(1) Make sure steam feeder is filled with water to MAX line.
(2) Make sure steam feeder is seated properly and drawer is
fully closed.
(3) Turn the dryer off then restart the Steam cycle.
steam generator will not work.
service.
after a short time.
severely restricted exhaust is dangerous and could result
in a fire or other property damage.
to make sure there is strong airflow.
rerouted.
Using the dryer with a