Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Install o ilfill pluganddipstick, t ightensecurely.
7. Wipeupanyremaining o il.
8. Reconnect sparkplugwiretosparkplug.
Service
Air Cleaner
Your engine will not run properly and may be
damaged if you run it with a dirty air cleaner.
Service the air cleaner once every 25 hours of
operation or once each year, whichever comes first.
Service more often if operating under dirty or dusty
conditions. Replacements
are available at your local
Sears service center.
To service the air cgeaner, follow these steps:
1.
Loosen screw and tilt cover down.
Tabs and Slots
Cartridge
Base
Screw Cover
2.
Carefully remove cartridge assembly.
3.
To clean cartridge, gently tap pleated paper side
on a fiat surface.
4.
Reinstall clean or new cartridge assembly inside
cover.
5.
insert cover's tabs into slots in bottom of base.
6.
Tilt cover up and tighten screw securely to base.
NOTE: You can purchase new air filter elements by
calling 1-800-366-PART.
Service
Spark
Pmug
Service the spark plug every 100 hours of operation or
yearly, whichever occurs first.
1.
Clean area around spark plug.
2.
Remove and inspect spark plug.
3.
Replace spark plug with recommended
plug if
electrodes are worn or if insulator is cracked or
chipped.
4.
Check electrode gap with wire feeler gauge and
set gap at 0.030 inches (0.76mm), if necessary.
.J
/
5.
Install spark plug, tighten securely.
NOTE: You can purchase a new spark plug by calling
1-800-366-PART.
Carburetor
If you think your carburetor needs adjusting, see your
nearest Sears service center. Engine performance
may be affected at altitudes above 3000 feet. For
operation at higher elevations, contact your nearest
Sears service center.
Spark Attester
Service
Your engine is not factoryzequipped
with a spark
attester. In some areas, it is illegal to operate an
engine without a spark attester. Check local laws and
regulations. A spark attester is available from your
nearest Sears service center. If you need to order a
spark attester, please call 1-800-366-PART.
The spark attester must be serviced every 50 hours to
keep it functioning as designed.
If the engine has been running, the muffler will be very
hot. Allow the muffler to cool before servicing spark
attester.
WARN NG
DO NOT touch
hot surfaces.
Allow
equipment
to coo! before
touching.
The pressure
washer
must be at least 5 feet from
structures
having
combustible
walls
and/or
other
combustible
materials.
Keep at least 3 feet of clearance
on al! sides
of pressure
washer
for adequate
cooling,
maintenance
and servicing_
In the State of California
a spark attester
is required
by law
(Section
4442 of the California
Public Resources
Code).
Other states may have similar
laws. Federal laws apply on
federal
lands. If you equip the muffler
with a spark attester,
it must be maintained
in effective
working
order.
Remove
spark
attester
screen
for
cleaning
and
inspection.
Replace
if screen
is
damaged.
Air Cooling
System
Over time debris may accumulate in cylinder cooling
fins and cannot be observed without partial engine
disassembly. For this reason, we recommend you have
an authorized Sears service dealer clean the cooling
system per recommended intervals (see "Maintenance
Schedule" on page 13). Equally important is to keep top
of engine free from debris. See "Clean Debris".
CLL,_/
16
Tabla de contenido
